Becker Beck-O-Tronic 6, Руководство по сборке и эксплуатации

Страница: 37 / 44

Cleaning
Only clean the outside of the housing with a suitable cloth. Do not use cleaning agents,
as these may damage the plastic.
Error messages
"Er" (Error) and the relevant error number flash alternately in the display to signal an er-
ror.
Error no. Description of error Comment / measure
01 EEprom data Switch off operating voltage, wait 10 s,
switch operating voltage back on. If the
error message persists, the saved menu
parameters are no longer correct. The
control unit must be reset (item Reset /
factory setting) and readjusted.
02 Motor current detection Switch off operating voltage, wait 10 s,
switch operating voltage back on. If the
error message persists, the motor current
detection is faulty. The control unit must
be replaced.
03 N-relay cutoff Switch off operating voltage, wait 10 s,
switch operating voltage back on. If the
error message persists, a short-circuit
has occurred in the N-relay. The control
unit must be replaced.
04 OPEN/CLOSE relay Switch off operating voltage, wait 10 s,
switch operating voltage back on. If the
error message persists, a short-circuit
has occurred in the OPEN or CLOSE relay.
The control unit must be replaced.
05 Watchdog test Switch off operating voltage, wait 10 s,
switch operating voltage back on. If the
error message persists, there is an error
in the control unit hardware. The control
unit must be replaced.
37