Installation
Software/Firmware Status – Functionality
28
ACU6100
DV64440.03 Issue 09 November 2019
Software/Firmware Status – Functionality
•
The software version of new deliveries is subject to change without notice.
2.3 Installation Requirements
The installation of the device(s) depends on the type of aircraft and its equipment and therefore only
general information can be given in this section.
The installation of ACU6100 into an aircraft may be carried out by an authorized
installation company. The country regulations always have to be obeyed.
•
The device must not be opened.
•
Keep enough distance to devices with integrated ventilator fans to make
sure the free circulation of the cooling air.
•
The installation area must have a minimum distance of 30 cm from the
magnetic aircraft compass, to prevent any interference to the magnetic
compass.
•
Forced cooling is not required.
ACU6100 is made for installation in cockpit environment of fixed and rotary wing
aircraft (depends on variant).
•
The installation must be in accordance with the local aviation authority
approved guidelines (e.g. EASA, FAA).
•
The personnel installing this device must make sure that the aircraft
installation conditions are in the ETSO/TSO standards applicable for the
specified type or class of aircraft.
•
The conditions and tests for ETSO/TSO approval of this article are
minimum performance standards.
•
The equipment is not qualified for installation in areas with fluid
contamination.
•
Changes or modifications made to this equipment not expressly approved
in written form by Becker may void the authorization to operate this
equipment.
