Becker Avionics
Operation
Loudspeaker Operation
DV64440.03 Issue 09 November 2019
ACU6100
59
3.12 Marker Mute
Marker Mute (depends on variant)
Marker Mute key
(depends on variant)
The marker mute function can be used for all RX-channels connected to a user.
A channel must be enabled for this function in the configuration*.
•
Push to the related key "MKR MUTE".
o
The preconfigured marker channels are muted for a predefined time
(cancel not possible, no reset).
•
The marker mute stops automatically after 30 s.
•
You cannot cancel the function.
NOTICE:
•
Only for ACU6100-X-(XXX5) Fixed Wing Variant.
*For more information refer to the software manual "CSW6100... "(www.becker-
avionics.com/downloads/ → Intercom).
3.13 Loudspeaker Operation
Loudspeaker Operation
Speaker key
The function "SPEAKER" must be enabled in the configuration*.
The DVCS6100 system has two speaker channels which are assigned by default
to ACU1 and ACU2.
•
Push to the key "SPKR".
o
The speaker is on.
o
The related LED is on.
o
All selected TX/RX channel signals and warnings are audible through the
loudspeaker.
NOTICE:
•
The default state for the loudspeaker on/off/last state can be set in the
configuration.
•
When PTT is pushed then the loudspeaker will be muted to prevent acoustic
feedback.
•
When the speaker is on voice-controlled intercommunication (VOX) function
is muted.
*For more information refer to the software manual "CSW6100... "(www.becker-
avionics.com/downloads/ → Intercom).
