67
80-1403-01, Rev. 3
BIST: BIST 2
Local control activity detected
The microcomputer has detected an data error
related to the local configuration interface. This
interface is not available with the fieldbus DCM‑3.
Demand Setting is out of limit
The Demand signal appears too high, and probably
has a data format error.
Current Overlimit
Not used in Group 14.
Power Source Not Nominal
Not used in Group 14.
BIST: BIST 3
Loop Current Detected while under HART/FF
Control
The microcomputer configuration does not appear
valid for Foundation Fieldbus.
BIST: ANALOG SIG SATURATED
Position out of accurate measurement range
The DCM-3 is reading a CPS-5 signal that is
outside of the range for accurate measurements.
Refer to OUTPUT SHAFT POSITION SENSING
(page 28).
Demand out of accurate measurement range
The Demand signal appears too low or too high,
and probably has a data format error.
Temperature out of accurate measurement
range
The DCM-3 ambient temperature reading is
extreme to the point of uncertainty.
Torque/Thrust out of accurate measurement
range
Not used in Group 14.
Содержание 14-100
Страница 85: ...85 80 1403 01 Rev 3 17 18 2 1 6 5 8 6 3 4 9 14 15 25 7 16 CONTROL ASSEMBLY AND DRIVE TRAIN...
Страница 87: ...87 80 1403 01 Rev 3 14 15 17 18 2 1 6 5 8 6 3 4 9 14 15 25 7 16 CONTROL ASSEMBLY AND DRIVE TRAIN...
Страница 90: ...90 80 1403 01 Rev 3 NOTES...
Страница 91: ...91 80 1403 01 Rev 3...
