BeaconMedaes dMED 100, Инструкция, Страница: 80 / 94

Condition Fault Remedy
Condensate is not discharged
from the separator Discharge pipe clogged Check and correct as necessary
Drain valve of separator
malfunctioning Remove drain valve assembly, clean and
check
For separator with EWD
(electronic water drain): EWD
malfunctioning Consult BeaconMedæs
Faults and remedies, filters
For all references below, consult section DD, PD and PDp filter change .
Condition Fault Remedy
The filter produces a whistling
noise Filter bowl not correctly
mounted Refit the filter bowl correctly
Bad filtration Filter element damaged
Water in sightglass Replace
Check functioning of water separator (WSD)
Insufficient air leaves the filter Filter clogged Clean the filter bowl and replace the filter
element
QDT filter
Condition Fault Remedy
Bad filtration Activated carbon lifetime
exceeded Replace the activated carbon at indicated
intervals
Wet air from CD in activated
carbon Check proper functioning of the CD dryer
Activated carbon not
compressed Check if spring is (properly) fitted
Too high CO concentration at
outlet Wet air from the CD dryer Check proper functioning of the CD dryer
Replace the desiccant at indicated intervals
Too much CO at inlet Check proper working conditions
Faults and remedies, ancillaries
Condition Fault Remedy
Inlet solenoid completely or
partially closed/opened • Electrical fault
•
Mechanical fault
• Check wiring
•
Replace defective parts
Pressure sensors:
malfunctioning Mechanical defect (e.g.
diaphragm ruptured) Replace defective parts
Instruction book
78 2920 7099 70