BeaconMedaes dMED 100, Инструкция

Страница: 30 / 94

Parameter Function Min.
setting Factory
setting Max.
setting Unit
Forced time To program the interval at which, if
activated by “System Forced”, the central
controller starts a new compressor in
case no sequence change has occurred
during the interval 1 1 60 days
Remote to local
time To program the time interval between
LAN and local commands from central to
compressor controllers 5 20 600 sec
Start/load time To program the time interval between the
different start commands from central to
compressor controllers 2 20 600 sec
Unload time To program the time interval between
different stop commands from central to
compressor controllers 2 20 600 sec
Delta time To program the difference in running
hours to allow the central controller to
decide starting another compressor 10 168 672 sec
System Forced
function To allow the central controller to force
another sequencing by starting a new
compressor at the interval programmed
in “Forced Time” 2 2 30 days
Maximum power
down time If <ArAF> is set to <Active> (e.g. instead
of <Infinite>), then the system will only
restart automatically within this power
down time 15 20 3600 sec
The following settings can be found under the ES Slave X submenu.
In normal circumstances they should not be changed, please contact BeaconMedæs.
Parameter Function Min.
setting Factory
setting Max.
setting Unit
Scheme X priority To put this compressor in a certain
priority queue, based on the scheme
selected (see master parameter
“Scheme In Use” )
1 1 6 -
Start/load
reaction time To program the time interval in which the
start command from the central controller
should result in the compressor running 1 20 600 sec
Stop reaction time To program the time interval in which the
stop command from the central controller
should result in stopping the compressor
1 35 600 sec
Running hours To adjust running hours for compressor
X to influence the even wear control
algorithm 0 X 500000 hrs.
Mode See below - integrated - -
Instruction book
28 2920 7099 70