BeaconMedaes dMED 100, Инструкция, Страница: 23 / 94

Bar graph Status Description
Idle compressor The compressor is idle and ready to be called. The bar graph is blank.
Lead compressor The central controller has assigned this compressor to be the next one
to run. This is indicated by a full line underneath the blank bar graph.
Called compressor This compressor is running. The bar graph is coloured.
Called compressor,
last one called This compressor has last started to run. This is indicated by a dotted line
underneath the coloured bar graph.
The table below describes the fault icons. More details in section Controller alarms and faults , paragraph Plant
fault.
Icon Status Description
No valid
compressor A compressor controller is expected at this CAN address node but not
detected.
No communication No reply from the connected compressor controller within a pre-defined
time.
Blinking network
icon The emergency forced local function is enabled on the compressor due
to the inlet pressure being too low. It will operate independently until this
function is reset.
No Answer Connected compressor controller is not responding correctly to the
commands (e.g. no reaction on a run command).
Not Available The compressor is stopped and is counting out the Minimum Stop Time
to prevent too many motor starts per hour. During this time the
compressor is not available to the ES control algorithm.
Compressor
Shutdown Compressor is in Shutdown condition.
Instruction book
2920 7099 70 21