75.5101 V1 Sep. 2003 [Rev. 9/22/2003]
Page 9 of 16
MANUAL SET-UP
(without remote)
SNOW MODE -
CANADIAN
CANADIAN SNOW MODE (FACTORY SETTING):
The Snow Mode is designed to minimize the effect of heavy snow on the Wizard’s auto-learn requirements.
Snow Mode may only be enabled by performing the following:
1. Using the BEA remote control, Unlock the Wizard as described in the programming guide.
+ unlock code, if necessary.
2. Set Infrared Sensitivity to LOW (1).
+ 1 = Low Sensitivity
3. Set Auto-Learn Time to 10 seconds (7 - FACTORY SETTING)
+ 7 = 10 second learn-time
4. Lock The Sensor when complete +
5. After the above changes have been made, the Wizard will go into the Canadian Snow Mode after it
goes through 2 auto-learn cycles within no more than 6 detection cycles of the sensor between these
2 auto-learn cycles.
6. While in Canadian Snow Mode, the auto-learn time will change from 10 seconds to infrared motion.
This mode will automatically expire upon a power reset, or upon expiration of one hour, as long as
the settings (as outlined above) are in effect. This mode could be launched again under the same
conditions.
•
Set-up of the Wizard may be accomplished by the use of two Wizard mounted programming buttons. The
procedures below indicate how to program using these buttons.
•
The two set-buttons are located at the right side of the Wizard (as viewed when mounted to header). To
begin, briefly press the right button and move away from the sensing patterns.
TO RESET THE UNIT
to factory defaults including the access code.
•
Press and hold both buttons simultaneously until both red and green LED lights flash alternately
TO CUSTOMIZE SETTINGS FROM FACTORY DEFAULTS
•
To enter the customizing mode: Press the right button until the LED light flashes and then release
•
To return to standard mode: Press the right button again until the LED light stops flashing and then release
CUSTOMIZING MODE
•
The red LED light indicates the number for the parameter being altered ( 1 flash = parameter #1)
•
The green LED light indicates the value for the parameter being altered ( 1 flash means value = 1)
•
The right button enables selection of the parameter number being altered ( +1 for each press)
•
The left button enables alteration of the parameter ( +1 for each press)
Manual Push-Buttons
IMPORTANT NOTE:
When changing the values of the above parameters to go from one mode to another, one should
force a set-up by remote control, push buttons, or by a power-off / on sequence.
OBSOLETE