75.5101 V1 Sep. 2003 [Rev. 9/22/2003]
Page 2 of 16
SAFETY
PRECAUTIONS
MECHANICAL
INSTALLATION
COMPONENT ID
ESD PRECAUTION
(ELECTRO-STATIC
DISCHARGE)
•
Shut off all power going to the header before attempting any wiring procedures.
•
Maintain a clean & safe environment when working in public areas.
•
Constantly be aware of pedestrian traffic around the door area.
•
Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected
reactions by the door.
•
Always check placement of all wiring before powering up to insure that moving door parts will not catch any
wires and cause damage to equipment.
•
Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.
1. Remove the cover from the unit as shown in picture “A”. After the Wizard is attached to the header, the
cover may be removed by inserting small screwdriver behind the Wizard and gently prying cover off as
shown in picture “B”.
2. Attach mounting template to the center of header as shown (C) – template should be 0”-2” above bottom
edge of header. Drill the hole marked for wire passage and drill pilot holes for screw mounting (D).
NOTE: Flush mount with bottom of header is necessary for for all neagtive IR angles.
3. Insert mounting screws about halfway in (F shown on next page), and install the Wizard onto the
screws. When in place, tighten screws to secure to header. Leave cover off until mechanical
adjustments are complete.
A
B
CABLE
COVER
MOUNTING SCREWS
MOTION SENSOR
FRONT LENSES
I.R. REMOTE RECEIVER
PRESENCE SENSOR
LED INDICATOR
MANUAL SET-UP
BUTTONS
2
nd
ANTENNA STORAGE
D
0-2”
BOTTOM OF DOOR HEADER
C
WIZARD MOUNTING
TEMPLATE
Circuit board components are vulnerable to damage by electrostatic discharge (ESD). ESD can cause
immediate or subtle damage to sensitive electronic parts. An electrostatic charge can build up on the
human body and then discharge when you touch a board. A discharge can be produced when walking
across a carpet and touching a board, for example. Before handling any board, make sure you
dissipate your body’s charge.
CAUTION: In the event a unit needs to be opened, observe the following precautions.
•
Ground yourself by touching a conductive surface of the door or other element connected to common earth ground to discharge
the static electricity present in your body.
•
Avoid walking around while replacing items inside the case, especially if you are on carpet or during conditions of low
temperature and low humidity.
•
Handle the board by the edges only to avoid touching electronic components.
•
Store a loose board in an anti-static bag.
OBSOLETE