BDV Phantom 800, Руководство пользователя, Страница: 19 / 78

. . . . .
G E T T I N G R E A D Y T O I N S T A L L
Final System Installation Overview
Phantom 800 User Guide Edition 1.06
13
S t e p 1 . E s t a b l i s h T e m p o r a r y R e m ot e C o n t r o l o f t h e P h a n t o m 8 0 0
Establish temporary remote control of the Phantom 800 through a laptop computer or
personal computer using the RS-232 serial interface. This allows control of the Phantom
800 so that the video signals going into and out of the processor can be tested.
S t e p 2 . C o n n e c t a T e s t D V I I n p ut S o u r c e
Connect a test DVI video source to Input 1 on the Phantom 800. Only a single DVI source is
required for the system test installation phase. Use Black Diamond Video tested DVI cable
to connect your DVI source to the Phantom 800.
S t e p 3 . C o n n e c t o ne o r m o r e D i s p l a y D e v i c e s a n d E s t a b l i s h V i d e o O u t p u t
Connect a display device to Output 1 on the Phantom 800. Connect additional display
devices as desired. Using the test DVI input connected in
Step 2 , use serial commands to
switch the input to each connected display device. Verify that all video displays or output
devices (such as DVD recorders, etc.) are functioning correctly.
S t e p 4 . T e s t a l l R e m a i n i n g I n p u t C h a n n e l s
Verify that all remaining input channels are functioning properly. Using the test DVI video
source, connect it to each input channel on your Phantom 800 and then route the signal to
each connected display device.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . F I N A L S Y S T E M I N S T A L L A T I O N O V E R V I E W
The final system installation should be performed after you have completed the system test
installation. You should have all of your video sources, cabling equipment, and display
devices assembled in preparation for the final system installation.
The final system installation consists of five steps. These steps are described below.
S t e p 1 . P l a c e t h e P h a n t o m 8 0 0 i n t o t h e R a c k mo u n t o r O t h e r P e r m a ne n t L o c a t i o n
The Phantom 800 can be installed in a 2U rackmount. Place your unit in its permanent
location before making any other system connections. Be sure to follow the safety warnings
regarding proper ventilation of the equipment.
NOTE:
If the computer you used in Step 1 has a DVI output, you can use it for the
test DVI video source in this step. This computer should have a built-in DVI
graphics card.
NOTE:
This is an overview of the system test installation to help inform and
prepare you for the actual installation process. For detailed installation
instructions, see Chapter 4, “Installation Instructions.”