BDDF00122 Issue 3
30/36
Alaris™ Gateway Workstation v1.3.x
Data Communications Interface Specifications
Wireless Ethernet Interface (where fitted)
Wireless Adapter:
Frequency Range and Power Levels:
Feature
Description
Operating frequency ranges (2 .4 GHz)
2 .4 GHz to 2 .5 GHz
Maximum Transmit Power (2 .4 GHz)
20dBm
Operating frequency ranges – 5 GHz
5 .15 to 5 .35 GHz (Europe ETSI)
5 .47 to 5 .725 GHz (DFS band)
Maximum Transmit Power (5 .15 to 5 .35 GHz)
23 dBm
Maximum Transmit Power (5 .47 to 5 .725 GHz)
30 dBm
The Dual Band Wireless Internet Adapter installed in the Workstation is in compliance with the essential requirements and other relevant
provisions of Radio Equipment Directive 2014/53/EU .
Features:
– IEEE 802 .11 a/b/g/n
– Connects to any existing 2 .4 or 5 GHz network
– Wi-Fi Protected Access (WPA, WPA2 and WEP) encryption
Note:
If you are upgrading from legacy Workstation to Workstation version 1 .3 .x, Features of RF card:
– IEEE 802 .11 b
– WEP encryption
– 2 .4 GHz
Auxiliary Interface
Connector Type: RJ45
Cable Type: CAT5e Ethernet Cable: As required
2
Isolation: 1 .5kV
Description
Pin 1: Tx+
Pin 2: Tx–
Pin 3: Rx+
Pin 4: N/C
Pin 5: N/C
Pin 6: Rx–
Pin 7: N/C
Pin 8: N/C
NOTES:
1
Assumes client equipment is non-medical equipment and outside of the patient environment; may be less than 1 .5m if the client
equipment is medical electrical equipment in compliance with EN 60601 .
2
Workstation may be used anywhere inside the patient environment .
3
Either a cross-over or straight through RS232 cable will be required . Refer to the Directions for Use of the device to be connected for
cable information .
