- 9 -
Assemble Instructions
Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are secure. Tighten again using the screwdriver provided if
necessary.
Estimated Assembly Time: 30 minutes.
Step 1
a) Loosen the two pre-installed bolts on the left front leg
(O) and allow the 1/4 bolt’s length to extend from the
left front leg (O). Align the holes on the
lower cart
front beam (U) with the extended bolts from the left
front leg (O).
b) Push down on the lower cart front beam (U) until
it locks into place. Tighten bolts by hand until
secured.
c) Align the holes on upper cart front beam(T) with
flat washer(CCC), spring washer(BBB), and bolt(AAA)
until it locks into place. . Tighten bolts by hand
until secured.
d) Repeat the procedure for the right front
leg (Q).
e) Go back and tighten all the bolts.
Step 2
a)
Loosen the four pre-installed bolts on the right back leg (P) and the left
back leg (K), and allow 1/4 bolt’s length to extend from the legs.
b)
Align the holes on the lower back beam (J) with the extended bolts from
the right back legs (P) & and left back leg (K).
c)
Pushes down on the lower back beam (J) until it locks into place, then
tighten all the bolts using screwdriver provided.
d)
Repeat the procedure for the upper back beam (I).
Step 3
a) Loosen the two
pre-installed bolts on the left back leg and the left front leg, and allow
1/4 bolt’s length to extend from the legs. Align the holes on the upper
side beam (V) with the extended two bolts on the legs. Push down on
the upper side beam until it locks into place; insert one bolt (AAA),
one spring washer (BBB) and one flat washer (CCC) into each hole on
the legs. Tighten by hand until secure.
b) Repeat the procedure for the right upper side beam assembly (V).
c) Loosen the lower two pre-installed bolts on the left front leg and back
leg, and allow 1/4 bolt’s length to extend from the legs. Align the
holes on the lower Cart side Panel (W) with the extended two bolts on
the legs. Push down on the side panel until it locks into place. Tighten
by hand until secure. Repeat the procedure for the right side panel
W).
d) Go back and tighten all the bolts using the screwdriver.