- 11 -
Step 8
a)
Place the body assembly (A) on the cart assembly.
b)
Align the holes on front legs with the holes on the body assembly(A), then
insert one bolt (AAA), one spring washer (CCC) and one flat washer (DDD)
into each hole. Tighten by hand until secure.
c)
Align the hole on each back leg with the holes on body assembly. Insert
one bolt (AAA), one spring washer (CCC) and one flat washer (DDD) into
each hole. Tighten by hand until secure.
d)
Go back and tighten all bolts using the screwdriver provided.
Step 9
a)
Loosen
the four pre-installed bolts on the side of control panel
and left back leg, and allow 1/4 bolt’s length to extend,
align the holes on the left side shelf (G) with the extended
bolts, then push down on the left side shelf until it clocks
into place, tighten by hand until secure.
b)
Repeat the procedure for the right side shelf (H) assembly.
c)
Go back and tighten all bolts using the screwdriver
provided.
Step 10
a)
Align the two holes on right side of body assembly with the two holes on the
right side shelf. Then insert one bolt (BBB), one spring washer (CCC) and one
flat washer (DDD) into each hole. Tighten by hand until secure.
b)
Repeat the procedure for the left side of the body assembly.
c)
Go back and tighten all bolts using the screwdriver provided.
Step
11
a)
Align the holes on side knob seat (CC) with the holes
on the right side shelf and side burner valve. Screw
one bolt (FFF) into each pre-drilled hole.
b)
Tighten the bolts using the screwdriver provided.
Insert the side knob (DD) into knob shaft of valve.
c)
Open the side burner lid and place the side burner
assembly (BB) on the right side shelf. Connect the
venturi tube and the side valve by overlapping 0.78”
between venturi tube and nozzle.
d)
Align the holes on the side burner assembly with the
holes on the right side shelf. Insert one bolt (FFF)
into each pre-drilled hole and screw by hand.
e)
Go back and tighten all the bolts using the
screwdriver provided.
f)
Connect the side burner ignition cable by inserting it onto the electrode. Make certain the connection is secure.
Step 12
a)
Place the four heat plates (D) inside the grill on the burners.
b)
Place the two cooking grids (C) inside the grill on the heat plates.
