11
39
11.2
O2 (Bayrosoft
®
) menu
The O2 menu consists of four submenus:
Configuration O2 (Bayrosoft
®
)
For setting all relevant parameters for the O2 automatic dosing system.
Average temperature
Display of the average measured temp. for the entire week and for each individual third of the week.
Date & time
For checking and, if necessary, correcting the setting of the current weekday, date and time.
Planned dosings
Display of the next planned dosings with date and time.
The main dosing and the two intermediate dosings are displayed.
If necessary, dosage planning can be reset in this menu.
In this case, the current planning is discarded and a re-planning is created based on the current weekday and date.
Note: Additional dosings are NOT displayed.
Additional dosings
For configuring the additional dosings as described below.
Configuration and Settings O2 (Bayrosoft
®
)
The following parameter settings are available:
Parameter
Value range
Standard settings (default)
Temp. Compensation
Off / Normal / High
Normal
The temperature compensation should be set to "High" if the amount of Bayrosoft
®
added
during the intermediate dosings proves to be too low.
Hose Config. O2
1,5 l/h / 3 l/h / ...
3 l/h
The dosing rate of the Bayrosoft
®
pump is entered here. This setting must match the actual
pump rate of the pump in use. Otherwise, Pool Relax will be unable to correctly calculate the
required pumping duration for a dosing and the dosed Bayrosoft
®
amounts will be incorrect.
Pool Volume
1...5000 m³
40 m³
When the pool volume is entered, the Bayrosoft
®
dose amount is automatically adjusted to the
pool size (0.5 litres per 10 m³ of pool volume).
Dose Amount O2
0.0...99.9 l
0.5 litres per 10 m³ of pool volume
(e.g. 2.0 l for 40 m³ of pool volume)
The basic dose amount for the O2 automatic dosing system is specified here.
The standard value derived from the pool volume can be adjusted again. The actual dose
amount of the main dosing and the two intermediate dosings depends on the measured water
temperature.
Dosing Day O2
Monday...Sunday
Friday
Weekday of the main dosing.
6s Dosing
Active / inactive
Active
After Pool Relax is switched on and no later than after 12 hours of operation, the Bayrosoft
®
pump is started briefly for approx. 6s to prevent product deposits.
11.3
Basic principles
The optimal amount of Bayrosoft
®
is added to the swimming pool water in several automatic dosings per week.
The dosed amount depends on the dose amount programmed on the device and on the measured water temperature. The
recommended setting for the dose amount is 0.5 litres per 10 m³ of pool volume.