41
TROUBLESHOOTING GUIDE
Troubleshooting Guide
Problem
Probable Cause
Remedy
No power to the
game.
Unplugged.
Power strip turned off,
or plugs unplugged.
Circuit breaker tripped.
Line filter faulty.
Bad or overloaded power
supply.
Check wall outlet cable (A5CORD5) to line filter in back
of game. (A5FI9010)
Check rocker switch on power strip. Ensure
power cords are pushed up into power strip securely.
Reset power strip breaker switch or building
circuit breaker. Attempt to determine cause.
Replace line filter. (A5FI9010)
Refer to Power Supply Diagnostics
Bill Acceptor on,
but everything
else off.
(Power Supply
not ON)
Power supply unplugged.
Rocker Switch on power
supply is Off.
Power supply shutting
down because of 12 V
overload.
Faulty power supply.
Insure power supply is plugged into power strip.
Make sure rocker switch is set ON.
See power supply diagnostics to isolate bad component.
A bad solenoid or 12 volt short would cause this.
Refer to Power Supply Diagnostics section.
Marquee LED
lights are not
working.
LED strip faulty
Faulty Cable
Remove marquee and examine LED strip. (AACE9612)
Check cables from LED strip to power supply.
(AACE9612, AACE9608)
Lighting inside
wheel not
working.
(AC Voltage)
One of 5 light bulbs out.
Socket faulty
Faulty Terminal Block
Faulty Cable
Faulty socket on power
strip.
Inspect light bulbs. Refer to “How to Access Light Bulbs
inside the Wheel” Replace if needed. (A5LI0003)
Swap light bulb from one socket to another. Replace socket
if needed. (AALIHL110)
Inspect Terminal Block and replace if needed. (A5TB9600)
Check cables from Light Bulbs to power strip.
(AALIHL110, AACE9619
Plug the AACE9619 into a different outlet strip socket.
Replace if needed. (AACE9606)
Left or Right
Side Guard Wing
LED’s not
working.
LED strip faulty
Faulty Cable
Faulty I/O Aux Board
Remove side guard and examine LED strip. Plug the
LED strip into the cable from the other side guard.
Replace if needed. (AACE9611)
Check cables from LED strip to I/O Aux Board
(AACE9611, AACE9615)
Replace I/O Aux Board. (Part # AACB9601)
Blue LED inside
arrow not
working.
LED strip faulty
Faulty Cable
Faulty I/O Aux Board
Slide open front plexi (Refer to: How to Open Front Plexi)
and examine LED strip. There should always be 12 Volts
present. Replace LED strip if needed. (AACE9613)
Check cables from LED strip to I/O Aux Board
(AACE9613, AACE9610)
Replace I/O Aux Board. (Part # AACB9601)
Содержание Jewel Mine
Страница 1: ...1...
Страница 52: ...52 DECAL DIAGRAM...