Bay Tek Games Jewel Mine, Руководство по обслуживанию

Страница: 25 / 55

25
HOW TO: CALIBRATE ENCODER SENSOR CONT.
HOW TO ACCESS: LIGHT BULBS IN WHEEL
Unplug game,
Unlock and remove the back door of game.
Remove the small Phillips screws from any large plexi panel.
Carefully bend plexi out of slots and remove plexi from game.
Light bulbs can now be accessed for replacement.
Part # A5LI0003
To re-install the plexi panel:
Bend the plexi and insert it into the grooves in the black plastic divider.
Carefully align the left and right edges with the existing score plexi on
the wheel.
The holes in the plexi should line up with the holes in the wood - insert
the small Phillips screws and tighten gently.
Remove 4 Phillips screws from rear black rail.
Slide window out the back of game.
Remember which direction it will go back in for installation.
To Install:
Push window into place and hand-thread all 4 bolts in to
start, then drill can be used to tighten.
If the pointer is more than 1/2” off:
If the arrow is too high on the space before it
registers, loosen the screw located behind the
arrow.
If the arrow is too low on the space before it
registers, tighten the screw located behind the
arrow.
Repeat as necessary.