[email protected] - www.bay-tec.de 5
Installation
The controller must be mounted on the platform inside the airframe by using one of the provided double-sided
tapes. When mounting, try your best to mount the controller as close to the C.G. as possible. Pay attention that
the edges of the controller unit are all parallel with the corresponding axes of the plane, and make it parallel to
the mounting platform. The controller can be attached flat or upright, and even upside down under the plane. The
illustration shows you the 4 different mounting orientations. However, no matter which orientation to select, you
have to ensure that the side of DATA interface is always pointing to the plane’s heading direction, otherwise the
stabilizer will not work properly.
VERY IMPORTANT!
1
．
You need only one piece of the double-sided tapes each time. A soft or thick mounting may probably
hinder the performance of the gyroscope.
2
．
Never use the hot-melt glue or nylon ties to fix the controller onto the airframe!
3
．
The controller is a sensing device, please make enough space around it and keep as far away from other
devices or wires as possible.
Flat
Horizontal Face Up
Flat Inverted
Horizontal Face Down
Upright
Vertical
Upright Inverted
Vertical Upside Down
