[email protected] - www.bay-tec.de 19
Basic Settings
Flight Mode
By using a 3-position switch, you can change the flight mode in flight, here you can assign your
desired flight mode for each position of the switch. If the input [MOD] is not connected, system will always
default to the mode that has been assigned to Position-1.
User Mode
Select different flight mode separately for aileron, elevator and rudder.
Response Rate
A3X Pro E.
uses a high sensitivity and high precision MEMs sensor, you need to try your best to
reduce the influence caused by vibration during installation. This option give you another way to filter the noise by
software. The default setting is Normal, usually it will be suitable for most planes. However, if you have made
effective measures to reduce the vibration, you can try a faster response rate setting to get a better performance.
On the contrary, you should use a slower rate when the controller is working in a high vibration situation.
Servo Frequency
It’s used to select the working frequency for the servos. To optimize the performance of the
controller, the rule is the higher the better! But please note that analog servos usually tolerate only 50Hz. Digital
servos usually allow higher frequencies, but this has to be verified in the manual of your servos. If you don’t know
what the maximum frequency tolerated by your servos is, please leave this option to its default setting.
A higher working frequency can lead to failure of your servos!
Travel Limit
This function is used to limit the maximum travel range for the servos. The max limit is determined
by the maximum possible control travel of the mechanism. The limits can be adjusted from 0 to 100%, the default
setting is 100%, corresponding to a pulse width from 1020uS to 2020uS. After setting a limit, the range of
movement of the servos will be limited within the safety range. The setting for aileron channel will be applied to
OUT1 and OUT4. The setting for elevator channel will be applied to OUT2 and OUT5. The setting for rudder will be
applied to OUT3.
Gyros
Here you can reverse the gyro or turn off the gyro separately for each channel.
