Bay Alarm Vista-20Bay, Инструкция по установке и настройке

Страница: 69 / 138

16–1
S E C T I O N 1 6
Data Field Descriptions
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
Introduction
♦
Descriptions of System Data Fields
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Introduction
The following pages list all data fields in the VISTA-20BAY in numerical order. If you have
performed the programming instructions that were included with the installation of each of
the peripheral devices covered in previous sections, this table will simply serve as a reference
for all data fields in the system. If you have decided to program all the data fields in the
system at one time (and therefore did not perform the programming indicated previously in
each section), you can use this listing to program all the data fields now.
Descriptions of System Data Fields
NOTE: The blank Programming Form should be used to record the data for this
installation. Defaults (where applicable) are indicated in text.
✱
20 INSTALLER CODE 4 | 1 | 1 | 2
The Installer code is used to enter the 4-digit Master security code in the
normal operation mode, via the keypad. See paragraph titled “Master Code”
in
Section 23: System Operation for procedure.
Enter 4 digits, 0-9.
✱
21 QUICK ARM ENABLE
0
0 = do not allow Quick Arm
1 = allow Quick Arm (the [#] key can be used instead of the security code
when arming the system)
✱
22 RF SYSTEM
0
0 = no RF receiver being used
1 = 5881/5882 RF receiver being used
4 = 5800 with RF Jam Detection
✱
23 FORCED BYPASS FUNCTION
0
0 = no Forced Bypass
1 = provide automatic bypass of all open (faulted) zones
All zones bypassed by this function are displayed after the bypass is initiated.
UL installations: Must be 0 (no forced bypass)
✱
24 RF HOUSE ID CODE 0 | 0
00 = disable all wireless keypad usage
01-31 = House ID
The House ID identifies receivers and wireless keypads.
If a 5827 or 5827BD Wireless Keypad or 5804BD Transmitter is to be used, a
House ID code MUST be entered, and the keypad should be set to the same
ID.