Bay Alarm Vista-20Bay, Инструкция по установке и настройке

Страница: 48 / 138

VISTA-20BAY Installation & Setup Guide
8–4
Programming the 4285/4286 VIP Module
You must program the system for use with the 4285 or 4286 VIP Module. This includes
assigning a phone code and selecting words from the Alpha Vocabulary List. Refer to the
programming sections for specific programming details.
Checking 4285/4286 VIP Module Operation
To Check Phone Module Operation From an On-Premises Phone:
1. Pick up the phone and enter the programmed 2-digit phone code. Annunciation of a
system status report should automatically start. See the User’s Guide accompanying the
phone module for detailed information regarding the nature of the status report, if
necessary.
2. During any pause in the status report, or immediately following it, key the following via
the keypad on the phone:
Installer code (4112) + # + 1 (OFF).
3. You should hear a beep on the phone and from a wired keypad. You should also hear the
words,
“Disarmed...Ready to Arm” or “Disarmed...Not Ready to Arm,” * indicating
that the command was entered successfully.
* “Disarmed...Not Ready To Arm” would indicate an open zone.
4. Hang up the phone.
To Check Phone Module Operation From an Off-Premises Phone:
1. Have someone dial the premises phone number, using a TouchTone phone.
• If the phone system does not include an answering machine, the caller’s phone emits 2
long tones followed by a voice prompt,
“Hello, Enter Phone Code Now. ” The caller
should enter the programmed 2-digit phone code.
•
If the premises phone system includes an answering machine, the caller should enter
the 2-digit phone code during a pause at the beginning of, or during, the outgoing
answering machine message.
2. After the caller enters the 2-digit phone code, a voice prompt asks the caller to enter the
4-digit system code
(“Enter System Code Now”) .
3. The caller should then enter the Installer Code (4112). As a safety feature, there is a 3-
try limit in which to enter each code (phone code and system code), after which time the
call-in will be aborted. Also, if no keys are pressed for a period of 20 seconds, the call-in is
aborted.
4. Annunciation of a system status report starts if both codes were entered correctly.
5. During any pause in the status report, or immediately following it, the caller should key
the following via the keypad on the phone:
Installer code (4112) + # + 1 (OFF).
6. The caller should hear a beep from the phone and from a wired keypad on the premises.
The caller should also hear the words
“Disarmed...Ready To Arm” or
“Disarmed...Not Ready To Arm” * on the phone, indicating that the command was
entered successfully.
* “Disarmed...Not Ready To Arm” would indicate an open zone.
7. At this point, the caller can hang up the phone.
8. Verify with the caller that there was successful access to the system and that the
appropriate annunciations were heard over the phone.
9. If the phone module functioned satisfactorily, unplug the AC transformer from the AC
outlet.