Baxi ECOGEN 24/1.0, Инструкция по установке и обслуживанию

Страница: 37 / 94

Fig. 34 & Fig. 35
Fig. 36 & Fig. 37
Fig. 38 & Fig.39
8. Adjust the two telescopic sections to dimension 'Y' ( Fig. 34 ). Ensure that the rivets and holes in the Connection Assembly are aligned horizontally ( Fig. 35 ).
9. Using a 2mm bit, drill through the holes at the end of the Connection Assembly into the Terminal Assembly and secure them together using the screws supplied ( Fig. 34 ).
Seal the joint with the tape provided ( Fig. 36 ).
10. Remove the flue elbow and insert the flue through the hole in the wall. Refit the elbow to the boiler adaptor, ensuring that it is pushed fully in ( Fig. 36 ).
11. Draw the flue back through the wall and engage it in the elbow. It may be necessary to use soap solution or similar to ease assembly of the elbow adaptor and flue ( Fig.
36 ).
12. Ensure that the terminal is positioned with the slots to the bottom ( Fig. 37 ). Secure the flue to the elbow with the self drilling screws supplied ( Fig.36 ).
IMPORTANT: It is essential that the flue terminal is fitted as shown to ensure correct boiler operation and prevent water entering the flue.
13. If necessary make good between the wall and air duct outside the building.
14. Fit the flue trim if required, and if necessary fit a terminal guard (see
Section 8.8 & 8.9 ).