17.5 To replace the burner.
(See figure 67).
1.
Remove the burner unit (See section 17.2).
2.
Support the elbow injector and unscrew the
injector nut.
3.
Remove the two screws from the burner clamping
plate (See figure 67).
4.
Lift the right hand side of the burner, slide it to
the right and lift clear
5.
Refit in reverse order.
17.6 To remove the main burner injector.
(See figure 68).
1.
Remove the burner (See section 17.5).
2.
Remove the burner clamping screw (See figure
68).
3.
Unscrew the injector from the burner.
4.
Refit in the reverse order.
17.7 To remove the appliance from the
fireplace.
1.
Remove the burner unit (See section 17.2).
2.
Slacken the hexagonal adjusters on the cable
adjusters and unscrew the thumbscrews to release
the cables.
3.
Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
17.8 To remove the Anthem, Aura 2, Debut, Blenheim, Homeflame Traditional,
Minima and Sonnet fascia.
Important : Before removing the fascia check to see if the foam seal covers
the flange on the rear of the fascia. If it does then ensure that a replacement foam
seal is available.
1.
Remove the appliance from the fireplace (See section 17.7)
2.
If the foam seal covers the flange on the rear of the fascia remove the foam seal from
the rear of the hotbox.
3.
Carefully lift off the top fascia piece and place carefully aside. Carefully remove the
two side pieces and place carefully aside.
4.
Refit in the reverse order (See section 8.2)
5.
If the foam seal was removed previously fit the replacement foam seal (See as in
section 8.3).
Page 42
INSTALLER GUIDE
Figure 68. Main burner injector
removal
Figure 67. Removal of burner
