12. CERAMIC PEBBLES INSTALLATION
This section is for models supplied with a ‘Pebble’ fuel effect only.
For ‘Coal fuel effect’ see section 11
12.1 Ceramic pebble fuel effect installation for Anthem & Aura 2 models.
The ceramic fuel effect may cause staining / discolouration to decorative surfaces. It is
therefore advisable to protect decorative surfaces.
1.
Place the base pebble in the firebox. It should
rest on the ledges at the rear sides of the burner unit
(See figure 36).
Install the 6 loose pebbles as follows. The
underside of each pebble is marked with a letter ‘A’
to ‘F’ and an arrow.
2.
The pebbles should be positioned so that the
arrows always point towards the back of the
fireplace opening. When located into position the
stem of each arrow should be at 90°
to the rear of the fireplace opening
(See figure 37).
3.
Hold pebble ‘A’ upright with the
arrow pointing to the top. Place
pebble “A” on top of the base
pebble (See figure 37).
Page 28
INSTALLER GUIDE
Figure 37.
Figure 36 Rear base pebble
position
