17.1 Checking the aeration setting of the burner.
1.
The aeration shutter is factory set. It is important to ensure that the aeration setting is
correct. Check the aeration shutter setting (See figure 63).
2.
To adjust the aeration setting to suit the model and fuel effect used, loosen the two
aeration shutter screws, slide the aeration shutter to the desired position and tighten the
screws.
17.2 To remove the burner unit.
1.
Remove the firefront casting and ash pan cover / firefront in the reverse order to that
shown in section 14.
2.
Remove the ceramic fuel effect. The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore advisable to protect decorative
surfaces.
3.
Support the inlet elbow to avoid straining the
pipework and disconnect the appliance from the
inlet elbow.
4.
Detach the burner unit from the hotbox by
removing two screws (See figure 64).
5.
Replace in the reverse order. The ceramic
fuel effect pieces must be replaced as in section
12 of this guide.
Page 40
INSTALLER GUIDE
Figure 64. Burner attachment points
Figure 63. Aeration shutter settings.
