12.2 Ceramic pebble fuel effect installation for Fusion, Quantum, Minima and
Camden models.
The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore
advisable to protect decorative surfaces.
1.
Place the rear base pebble in the firebox. It
should rest on the ledges at the rear sides of the
burner unit (See figure 43). When located, gently
move the rear base pebble so that it is as far
forward as possible. The amount of movement will
be negligible.
2.
Place the front base pebble in the firebox with
its bottom front locating over the front rim of the
firebox. Gently pull it forward so that it locates
immediately behind the front rim of the firebox
(See figure 44). The front base pebble will touch
the rear base pebble as it is located.
Install the 7 loose pebbles as follows. The
underside of each pebble is marked with a letter
‘A’ to ‘G’ and an arrow.
The pebbles should be positioned
so that the arrows always point
towards the back of the fireplace
opening. When located into
position the stem of each arrow
should be at 90° to the rear of the
fireplace opening (See figure 45).
3.
Hold pebble ‘A’ upright with the
arrow pointing to the top. Place
pebble “A” on top of the front base
pebble. The pebble should sit in
the recess on top of the front base
pebble (See figure 45).
Page 30
INSTALLER GUIDE
Figure 45.
Figure 44. Front base pebble
position
Figure 43. Rear base pebble
position
