USING THE HEATER
Important Safety
Never cover the heater or obstruct the openings at the base of the heater, this could
cause overheating and consequent risk of fire.
What are the three switches for?
The heater is operated by three switches located below the hood on the left hand side of
the heater.
Switch 1 =
Main On - Off. (In the ‘ON’ position, only the flame
effect operates)
Switch 2 =
1kW fan heat setting and flame effect. (Switch 1 needs to
be in the ‘ON’ position to enable switch 2 to operate).
Switch 3 =
2kW fan heat setting and flame effect. (Switch 2 needs to
be in the ‘ON’ position to enable switch 3 to operate).
CLEANING AND MAINTAINING THE HEATER
How do I clean my heater?
The heater fascia and glass parts need only to be wiped clean with a dry soft cloth, do
not use polishes or abrasive materials. The Adage and Anthem heaters may have finger
prints on the fascia surface. These can be removed by applying a small amount of ‘baby
oil’ to a lint free non-abrasive cloth and wiping the surface. Use a clean cloth to remove
the oil.
I have a problem with my heater!
Important Safety
Before undertaking maintenance or replacing the light bulb(s) always disconnect
the heater from the electricity supply by removing the 3 pin plug and allowing the
heater to cool completely.
1. My heater is on but there is no light or the light appears brighter on one
side of the heater.
This is possibly a light bulb failure. Remove the light bulb(s) as follows and check it /
them in a table lamp that is known to work. If it / they do not work in the table lamp
then replace as below.
Page 17
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
