Fitting the light diffuser.
1.
There is a light diffuser supplied with the heater (See figure 5). Place this on to the
metal flange below the plastic screen (See figure 12).
Fitting the Fascia
Important notes.
1.
The coal pieces supplied are a natural material. Occasionally it will be necessary
to reduce the size of the coal pieces. To do this place them inside a plastic bag, place
on a suitable hard surface and tap gently with
a small hammer or similar tool.
2.
The pebbles and coals are for decorative
purposes only. There is a choke risk to
young children. Make sure they cannot
gain access to them.
Fitting the Adage fascia.
1.
Removing the fascia may have moved the
magnets used to fix the fascia to the heater.
There should be a magnet on each of the four
raised tabs on the rear of the fascia (See figure
13).
2.
Locate the fascia onto the heater. Ensure that
the sides of the fascia sit on the floor / hearth.
3.
Place the loose coals / pebbles onto the fuel
support (a glove is provided with the coal pack).
It is not necessary to use all the fuel effect pieces
supplied.
Fitting the Decadent, Eternal, Obsession and
Victorian fascia.
1.
Hook the brackets on the rear of the fascia over
the brackets on the heater (See figure 14).
2.
Secure with the two screws removed previously.
3.
The rear of the firefront has two screws that
locate into ‘keyhole’ brackets on the heater (See
figure 15).
(On Victorian models screw the brass
finials supplied with the firefront into the top of the
firefront)
.
4.
For models supplied with ash pans (The lower
part of the firefront) place the ash pan in position.
5.
Place the loose coals or pebbles onto the fuel
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 14. Fitting the facia. The
fascia shown is the ‘Dream’.
The Bolero, Carma, Eternal,
Obsession and Victorian fascia
fit in the same way.
Figure 13. Magnet locations for
Adage model.
