14.3 Fitting the Victorian firefront.
1.
Fit the finials to the top of the firefront
casting by screwing them into place.
2.
Place the firefront casting centrally on the
hearth in front of the fascia.
3.
Place the bottom front cover casting in
position below the fire front casting.
14.4 Fitting the Anthem firefront.
1.
The Anthem firefront is fitted with a set of
fixing brackets. Each bracket has two threaded
holes. As supplied the top threaded hole should
be fitted with a 25mm long machine screw.
Remove the machine screw and locate to the
threaded hole below.
2.
The screw should be set at a distance of
7mm (Measured from the surface of the
bracket to the underside of the screw head).
Adjust the screw to this distance (See figure
31).
3.
Locate the firefront as in figure 32. The
screw heads should locate into the slots in the
burner tray.
4.
The lower 'ash pan' casting should be
located as in figure 33.
14.5 Fitting the Camden,
Seattle and Minima firefront.
1.
Place the firefront centrally on
the hearth in front of the fascia.
Page 32
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 33. Lower ‘ash pan’ location
Figure 32. Hanging the
firefront
Figure 31. Anthem bracket locations
