Baumatic BMEH94I1G, Инструкция по использованию и установке

Страница: 16 / 48

16
Switching the alarm off
When the preset time expires a beep is heard which you can either turn off by touching
any sensor or leave it to turn off automatically after 2 minutes.
If you want to switch the timer off prior expiry of preset time:
• Touch the sensor (F).
• Pressing on the far left side of the slider. Alarm function is off.
• During the time the alarm is activated, timer can not be preset for any hotplate. To
enable timer setting function, alarm must be switched off.
Cooking zone
configuration Prerequisites for configuration/deleting (configuration)
▪ All pans must be removed from cooking zones and one suitable for induction must be
available.
▪ It’s possibile starting configuration/deleting within 2 minutes after connection to power
mains. Touch control and all displays must be turned off.
Getting in configuration/deleting menu’
▪ Hold the key (2) pressed.
▪ Press all keys of cooking zones’ selection anticlockwise, starting off with:
▪ the front right one for VI4740229F (3-4-5-6)
▪ the rear right one for VI3600229F (4-5-6)
Every action is acknowledged by a signal tone:
#
Only one “beep” → correct selection
#
Double “beep” → wrong selection
▪ After the last action all induction displays turn on, where it’s displayed:
#
“-“ → it means configured zone
#
“C” → it means NOT configured zone
Procedure of deleting configuration
After getting in configuration/deleting menù:
▪ Hold the key (2) pressed: “E” is displayed on the displays of all cooking zones. “E”
keeps flashing until all cooking zones will be not configured.
▪ “C” will be displayed on all displays.
Procedure of configuration
After getting in configuration/deleting menu and completing deleting configuration:
(During configuration phase all displays of cooking zones display “C”)
▪ Cooking zone to be configured can be selected by cooking zone’s selection key
(3,4,5,6).
▪ “C” will start flashing on the corresponding display.
▪ Within 20 seconds a pan must be placed on the corresponding zone in the way that the
cooking zone can detect the correct position:
#
If within 20 seconds cooking zone detects a pan the simbol “-“ will appear (cooking
zone is correctly configurated);
#
If after 20 seconds cooking zone doesn’t detect a pan the letter “C” will appear; try
again configuration procedure from the first point.
This procedure must be applied to every cooking zone.
Configuration menù stops:
▪ Automatically after the configuration of all cooking zones.
▪ Manually by pressing the key (1), if you want to configure only certain cooking zones.
At the end of it it’s advisable testing hob to verify that the configuration is successful.