Baumatic BMEH94I1G, Инструкция по использованию и установке

Страница: 14 / 48

14
Recall
By using this function the settings may be recovered quickly, when the control was
switched off with the main switch by mistake. After switching off with the key (A), the
operator has 6 seconds to switch on again the control and another 6 seconds to actuate
the key (D).
Remaining heat indicator When an active hotplate is switched off, or when the entire hob is switched off, the
indicator (E) displays »H«, as a signal that a particular »hotplate is still hot«. Display time
is calculated in relation to the used heating power and the period the hotplate was active
prior switching off. Even when warning signal “H” disappears, hotplate may still be hot in
certain cases (power failure, leaving any temperature sensitive objects on the hotplate).
Be careful, danger of burns!
Extra powerful setting
(hotplates marked “P”)
Extra powerful setting may be additionally switched on for fast cooking on indicated
hotplates. This extra hotplate power is used for heating large quantities of food.
After switching on, the extra power is activated for:
• 8 minutes for cooking zones Ø200/250mm marked by the letter P, then automatically
switches back on to the maximum normal level 9.
• 90 minutes for cooking zones Ø160mm marked by the letter P, then the cooking zone
switches off.
During the time extra power is activated, the power of other hotplates is limited. This is
indicated on the power display (E) by intermittently flashing the selected cooking level
and limited power for a few seconds.
Activating extra powerful setting
• First select the hotplate by touching its relevant sensor, and immediately after press the
sensor (C).
Extra powerful setting is on, and power indicator (E) displays symbol “P”.
Premature turning extra powerful setting off
Touch the desired hotplate sensor (E), and immediately after press the sensor (C). Letter
“P” disappears and the hotplate automatically switches to level 9.
Automatic fast heating
This function preheats the burner on maximum power in order to bring it rapidly up to the
required temperature. After a given time interval, the power level returns spontaneously
to the established setting.
It may be switched on in any of the hotplates for all power settings except for setting “9”
where power is set at maximum all the time.
Activation of automatic fast heating
Automatic cooking mode is activated on any idle hotplate.
• Select a particular hotplate, power indicator displays “0”.
• First touch of the slide sensor (B) must be to the extreme right, followed by a new
pressure level 9. (E) indicates “A”, automatic cooking mode is on.
• Until the decimal point (E1) flashes, it is possible setting the desired power level (8...1)
further by touching the slide sensor.
• D isplay alternate “A” and the level set cooking
Once the time in the chart below expires, the function is switched off and “A” disappears.
You can also switch the automatic cooking mode off anytime by modifying power level.
Safety switch off
Maximum continuous operation of a particular hotplate is limited, and the duration is
displayed in the above chart. When the hotplate is switched off by the safety mechanism,
the indicator displays symbols “0”, or “H” in case there is any remaining heat left.
In such cases switch the hotplate off by touching the relevant power setting sensor (B).
Example: Set the hotplate to power level 5 and leave it operate for some time. If you do
not change the above setting, the safety mechanism will switch the hotplate off after 4
hour and a half.
Power setting 1 2 3 4 5 6 7 8 9
Maximum
power cooking
time (min.)
0,8 2,4 3,8 5,2 6,8 2,0 2,8 3,6 0,2
Power setting 1 2 3 4 5 6 7 8 9
Hours lapse prior safety
switch off
6 6 5 5 4 1.5 1.5 1.5 1.5