Basler Vision Technologies Sprint Series, Руководство пользователя

Страница: 220 / 236

Troubleshooting and Support
210 Basler sprint Mono Cameras
Check the setup on your frame grabber
and make sure that the ExSync signal
period is not too short. The period of the
ExSync signal must not be lower than
the calculated minimum as explained in
Section 4.3 on page 74 . You can also
access the line period CSR (see
page 171 ) to check the minimum.
(On many frame grabbers, the period of
the ExSync signal is adjusted by
changing a setting for the “line rate”.
Your line rate should not exceed
1/line period.)
Is the ExSync period OK?
Yes
No
Correct
the
settings.
Check your exposure setting.
The exposure time must be at
least 1.3 µs less than the
ExSync period.
Is the exposure OK?
Switch on test image one.
Can the test image be seen?
Correct
the
setting.
Go to the
interfacing
troubleshooting
chart.
Replace the camera.
No
No
Yes
Are you controlling the camera
with an ExSync signal or is the
camera in free run?
ExSync signal.
Free run.
CCT+
Check to make sure that:
The exposure time is set no
lower than 2.0 µs.
The line period is set no lower
than the minimum stated in the
line period CSR (see
page 171 ).
Are the settings OK?
No
Correct
the
settings.
Binary
Commands
Did you set up free run using the
CCT+ or with binary commands?
Yes
Yes
Switch on the test image one.
Can the test image be seen?
Go to the
interfacing
troubleshooting
chart.
Replace the camera.
No
Yes
Check to make sure that the RS-644 serial connection (see Section 2.9 on page 37 )
is working correctly. You can do this by starting the Camera Configuration Tool Plus
(CCT+). When you start the tool, a startup graphic should appear and then a window
that shows a list of parameter settings should appear.
(If this is the first time that you are using the tool, you will see an empty window with
a drop down menu at the top which says “No port selected”. In this case, use the
drop down menu to select the RS-644 port that you want to use. RS-644 ports are
identified in the list by a name starting with "clser" followed by a port number. Once
you select the correct port, the list of parameter settings should appear.)
Did the list of parameter settings appear?
Go to the
RS-644
serial
communications
troubleshooting
chart.
No
Yes