Basler Vision Technologies Sprint Series, Руководство пользователя

Страница: 159 / 236

Features
Basler sprint Mono Cameras 149
6.12 Configuration Sets
A configuration set is a group of values that contains all
of the parameter settings needed to control the camera.
There are three basic types of configuration sets: the
work configuration set, the factory configuration set,
and user configuration sets.
Work Configuration Set
The work configuration set contains the camera’s
current parameter settings and thus determines the
camera’s performance. If you use the CCT+ to change
the camera settings or if you change settings by writing
to the camera’s registers, you are making changes to
the work configuration set. The work configuration set
resides in the camera’s volatile memory and the settings are lost if the camera is reset or if power
is switched off. The work configuration set is usually just called the “work set” for short.
Factory Configuration Set
When a camera is manufactured, a test setup is performed on the camera and an optimized
configuration is determined. The factory configuration set contains the camera’s factory optimized
parameter settings. The factory set is saved in a permanent file in the camera’s non-volatile
memory. The factory set can not be altered by the user and since it is stored in non-volatile memory,
it is not lost when the camera is reset or switched off. The factory configuration set is usually just
called the “factory set” for short and is named
FactorySet .
User Configuration Sets
As mentioned above, the work configuration set resides in the camera’s volatile memory, and the
parameters settings in the work set are lost if the camera is reset or is switched off. The camera can
save the parameter settings from the current work set to a file in the camera’s non-volatile memory.
Files in the non-volatile memory are not lost when the camera is reset or switched off. There are
four files in the camera’s non-volatile memory available for holding a saved configuration set. A
configuration set saved in one of these files is commonly referred to as a "user configuration set" or
"user set" for short.
The four files available for holding a saved user configuration set are called, UserSet01 , UserSet02 ,
UserSet03 , and UserSet04 .
Fig. 49: Configuration Sets
UserSet01
UserSet02
UserSet03
UserSet04
Work Set
Factory Set
Non-volatile
Memory
(flash)
Volatile
Memory
(RAM)