Basco Infinity 1413, Руководство по установке

Страница: 9 / 11

Cut four pieces of the smaller vinyl [ HH ] 1”
longer than the vertical opening (to prevent gapping
from shrinkage) and trim the ends on a 45 ° angle.
Using the masking tape guides, center the glass panel
[ F ] in the frame. Cut four short (1” – 2”) pieces of the
small vinyl and press into the jamb and post on each
side to hold the glass temporarily.
Take one of the long pieces of vinyl, and starting on the
outside exterior jamb, press each end into the frame and
work toward the middle. Be careful not to stretch the
vinyl. Install the other three pieces in a similar fashion.
16
GLAZING
VINYL
WALL
JAMB GLASS
PANEL
180
POST
45
ANGLE
Cut four pieces of the larger vinyl [ JJ ] 1/2”
longer than the horizontal opening and trim the ends on
a 45 ° angle. Install the top exterior vinyl starting at
both ends and working toward the middle. Be careful
not to stretch the vinyl.
Install the top interior vinyl and the two bottom vinyls
in the same way.
17
GL
ASS P
ANEL
HEADER
GLAZING
VINYL
CURB
GLASS
PANEL
SETTING
BLOCK
Carefully caulk the interior jamb-to-wall and
curb-to-base joints. For appearance, you may wish to
caulk the exterior joints as well. We recommend you
wait twenty-four hours before the first shower to allow
the caulking to cure properly.
18
CAULK
Note: Do not caulk over weep holes
GL
ASS P
ANEL
QCI0029 REV. 1 Page 9 of 11 Certified 07/06/05