Wipe the shower walls and sill, the curb [
A
] and
the wall jambs [
B
] with a clean, dry cloth to remove
any dust or debris. Apply a 1/4” bead of caulk along the
inside of both of the pencil lines marked in Step #
2
.
Carefully replace the curb in the exact position marked.
Caulk the inside of the curb ends where they meet
the wall.
Replace both wall jambs and attach to the
walls with six #8 x 1 1/2” truss head screws [
D
].
4
#8 x 1/2”
SCREW
WALL
JAMB
CURB
CAULK
WEEP SLOT
TO INTERIOR
Place two setting blocks [
E
] into the curb [
A
] to
support the fixed glass panel [
F
]. Position the blocks 3”
from each corner of the glass panel. Set the glass panel
into place on the setting blocks and approximately 1/2”
into the wall jamb [
B
]. A strip of masking tape 1/2”
from each vertical edge of the glass will aid alignment.
NOTE: Obscure or etched glass panels should be
installed with the rough or patterned surface of the
glass to the exterior of the unit.
Press the 180
°
post [
G
] into the curb and position to
overlap the glass panel by 1/2”. Use masking tape to
hold the post in position temporarily.
NOTE: To facilitate out-of-plumb walls, the 1/2” glass
bite may be varied from 1/4” to ¾”.
5
WALL
JAMB
1/2”
GLASS
PANEL
1/2”
180
POST
GLASS
PANEL
CURB
SETTING
BLOCK
Measure the wall-to-wall opening at the top of
the wall jambs [
B
] and cut the header [
H
] to fit the
exact opening. Using a 3/16” drill bit, drill the interior
face of the header on both ends as shown. These holes
may be pre-drilled from the factory.
6
R
O
I
R
E
T
N
I
MEASURE AT TOP
OF WALL JAMB
”
8
/
3
1/4”
HEADER
.
A
I
D
”
6
1
/
3
LE
N
AP
SS
AL
G
