There are six hardware components for back-to-back mounting: two pulls and four 1-1/4” diameter
style washers. In addition to these hardware parts, there are four clear gaskets and two stud head
screws. A decision must be made at this time as to the location of the half of the pull that contains the
set screws. Most put the set screws to the outside of the enclosure, so they are not exposed to direct
water contact. These instructions will address this application.
STEP1
Take the two stud head mounting screws and sleeve on 1-1/4” style washer on each
screw. Next, sleeve one of the clear gaskets onto the screw. From the outside of the enclosure, push
the thread of the screw through the hole in the glass. On the inside of the enclosure, sleeve a clear
gasket onto the threads of the screw. Place the 1-1/4” style washer over the threads and onto the glass.
STEP 2
Take the pull that has the smaller threaded holes in each end and begin to thread the
screw into it. Line up the other end of the pull with the other screw and begin to thread it through as
well. Tighten both screws to “finger-tightness”, then tighten the stud head screws down permanently
with a screwdriver.
STEP 3
Place the remaining pull, with the large holes in each end as well as a set screw, onto
the stud heads of the screws. Tighten the set screws with the Allen wrench provided.
J
SC1417 Interior & Exterior handle (1 ea.)
K
L SC4584 Metal washers (4)
M SC4585 Large clear discs (4)
N SC4586 Small clear discs (4)
O SC4587 Glass hole sleeve (2)
P SCR1588 Stud screws (2)
J
K
L
M
N
O
P
Back-To-Back Door Pull or Towel Bar Mounting Instructions
QCI0029 REV. 1
Page 11 of 11
Certified 07/06/05
