Bartscher US PPlus500 LPWR, Инструкция по эксплуатации и техническому обслуживанию, Страница: 27 / 29

EN
page 55
9. ENVIRONMENTAL ASPECTS
9.1 Packaging
Packaging is made of the following components:
•
a wooden pallet;
• a nylon sack (LDPE);
• a multi-layer carton;
• polystyrene (PS) strips;
• polypropylene (PP) banding.
All above materials, shall be disposed and treated in accordance with the Local Laws in force.
9.2 Disposal
The symbol WEEE/RAEE used on this product indicates that it cannot be treated as domestic waste. Proper
disposal of this product contributes to protecting the environment. For more information on product recycling,
contact the local authorities, domestic waste authorities or the dealer where the product was purchased.
For product or parts disposal, follow the Council directives 2011/65/UE and 2012/19/UE as amended and/or
application legislative decrees.
The present product or parts cannot be disposed of as urban waste but shall be collected in separate containers (see the
waste bin on wheels symbol with an “X” on the product).
At the time of product disposal, the user shall refer to the waste electrical and electronic equipment (WEEE/RAEE) speci
fi cation.
The manufacturer guarantees the absence of dangerous substances in the EEA used in conformity to the directive 2011/65/UE.
If the user does not comply with the regulations he/she shall be subject to the penalties foreseen by each member state.
Disconnect electricity and water before disposal.
Cut away the electrical cable to ensure that further use is impossible.
All metal parts are recyclable as they are made of stainless steel.
Recyclable plastic parts are marked with the plastic material symbol.
10. TROUBLESHOOTING
Type of Problem Possible Causes Cure
The machine does not
turn on Main switch not ON. Turn switch ON.
The machine does not
load water. Water valve shut. Open the water valve.
Rinse nozzles or solenoid-valve
fi lter blocked and/or scaled with
limestone.
Clean the rinse arm nozzles, piping and solenoid-valve fi lter.
If the machine is equipped with a water softener check the
salt content or regenerate the resins more often
Defective pressure-switch. Replace pressure-switch.
The machine loads water
very slowly Scarce water supply pressure Check the water supply pressure
Rinse booster pump blocked (if
installed) Contact Technical Service.
Wa s h i n g r e s u l t s a r e
unsatisfactory. The washing nozzles are obstructed
or the rack does not rotate. Remove the wash rack and clean the wash nozzles. Check
the right positioning of the wash-arm, tightening
fi rmly.
Foam is present Use no-foam detergents or reduce the dose in use.
Fats or starches not removed. Insu ffi cient detergent concentration.
Filters are dirty. Remove fi lters, clean with brush under a jet of water and
replace in original position.
Check tank temperature (which
must be between 55°C and 60°C). Contact Technical Service.
Wash time insu ffi cient for the type
of dirt.
Select a longer wash-cycle, if possible, otherwise repeat
the wash cycle.
Wash water is dirty. Drain the tank water, clean the fi lters; re fi ll the tank and
replace the fi lters correctly.