Bartscher US PPlus500 LPWR, Инструкция по эксплуатации и техническому обслуживанию, Страница: 11 / 29

EN
page 39
3. OPERATION
3.1 Machine start-up
3.1.1 Start-up
• Insert the over fl ow pipe in the special seat inside the tank. Make sure all the fi lters are properly fi tted in their seats (see
pic. 2). The fi lters must be cleaned every 30-40 wash cycles and whenever necessary.
Do not operate the machine without filters and in particular the pump suction filters.
• Close the door.
• Turn the water valve “open”.
• Turn the main power switch ON.
• The machine is on
STAND-BY . In the G display are shown: the date (dd/mm on the right) and time (hh/mm on the left).
• Keep pressed the key E .
• The machine start will be active when the key Start A fl ashes . After a few seconds the tank fi lling phase starts. The F2
indicator and the F1 temporizer (left to right) light on. Should the machines be equipped with the WRAS certi fi ed Break Tank
or fed by an osmotic-water device, the tank- fi lling phase will be longer.
• After fi lling, the machine automatically starts the heating phase. The phase is displayed by the Start A key fl ashing (green) .
The tank and boiler indicators F17 and F12 switch on. The indicator F5 switches on .
The machine is ready to wash when the set temperatures are reached. The indicator F5 switches o ff . The Start A key stops
fl ashing.
pic. 1
• Insert the special green rinse aid dispenser tube in the liquid rinse aid container and check that the quantity is su ffi cient for
the daily requirement. The transparent tube (if present) must be inserted in the detergent container.