Installation Instructions
117910
23 / 68
EN
5.3
Water Connection
1. Make sure that the potable water connection is located close to the appliance.
2. Prior to establishing the water connection, flush with enough water to remove all
residues of substances that might be present in tubes, so that they do not enter
solenoid valves.
3. In order to utilise the water connection, consider the following information:
– The water supply connection is located at the rear of the appliance, to
the left-hand side. The connection to the distribution network valve can
be made using the supplied flexible pipe or with a ¾" threaded pipe. The
connection must be made in such a way that it cannot be removed in the
event of a pressure overload. Illustration of water connection and water
drain is shown in the below Fig. 5.
– Before connecting the water supply to the oven, install a pressure
regulator and set it to 2.5
–3.5 bar (50–200 kPa). A filter must be installed
before water is delivered to the oven.
– The on-site water supply must be fitted with a shut-off valve that may be
used to shut off the water supply to the appliance.
– Check the hardness of the water on site or ask your local water supply
company.
