Bartscher 2951121, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 164

14
ENGLISH
GB
9.1. Minimum setting of the hob burner valve
These settings are required only if the connected
gas type differs from the factory preset and
checked gas, after switching to the different gas
type.
Before performing this setting check whether the
gas pressure is compliant with the value of nominal
pressure (see table in the appendices).
Follow the instructions below.
1. Close the gas cut-off valve.
2. Pull the control knob ( A).
3. Unscrew screws B and remove the control
panel ( C ).
4. Slowly move the button from position ( 7)
clockwise to the minimum flow position ( D )
(just before the blockade). Turn the screw
(
D ) counterclockwise in order to increase
the gas flow. After setting tighten the screw.
5. Finally reinstall the control panel ( C ) and
control knob ( A ).
9.2. Minimum setting of the oven burner valve
These settings are required only if the connected
gas type differs from the factory preset and
checked gas, after switching to the different gas
type.
Before performing this setting check whether the
gas pressure is compliant with the value of nominal
pressure (see table in the appendices).
Follow the instructions below.
1. Close the gas cut-off valve.
2. Pull the control knob ( A ).
3. Unscrew screws B and remove the control
panel ( C ).
4. Remove the injection nozzle D and replace
it with the one suitable for used gas type
(see appendices). After setting tighten the
screw.
5. Finally reinstall the control panel ( C ) and
control knob ( A ).
After completing all calibration and
settings, check the tightness of gas system
and proper operation of the device.
Make sure that the flame is stable with
minimum or maximum output pressure.
When the setting is done, install the prepared
seal and/or seal the adjustment screws.
C
A
B
D
D
C
A
B
ID 09
ID 13