Baroness LM351, Руководство по эксплуатации для владельца

Страница: 60 / 75

Cutting Work
Cutting Operation
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Important
Perform cutting work with the mower unit up/
down lever shifted to the "DOWN" position.
Reel rotation will be turned off when the
mower unit up/down lever shifted to the
"NEUTRAL" or "UP" position.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Shift the reel rotation/stop switching levers of
all mower units to the "Rotate" position.
Set the pedal stopper to the "Working"
position.
Start the engine.
(Refer to "Procedure to Start Engine")
Shift the throttle lever to the "High speed"
position, and rev up the engine to MAX.
Release the parking brake.
Right before starting cutting work, set the
anti-falling stop valve to the "Open" position.
Lower the mower units.
Set the reel rotation switch to the "Rotate"
position to rotate the reel cutters (cutting
cylinders) for all mower units.
Depress the traveling pedal to start cutting
work. 1.
2.
3.
4.
5.
6.
7.
8.
9.
Transporting
Transporting Procedure
Important
If the roof is installed on the machine, remove
it.
Otherwise, the roof may be damaged by wind
pressure.
Important
Be sure to use cables strong enough to
secure the machine.
When loading the machine onto a truck or a
trailer for transport, follow the steps below.
Loading the machine
Remove the roof. (If the roof is installed on
the machine)
Start the engine.
Travel slowly to load the machine onto a
truck or a trailer.
Stop the engine.
Raise all the mower units.
Fasten the machine with ropes.
For fastening the machine with ropes, use
the following positions.
Front part of the machine: Use tow
hooks on the right and left side of the
frame.
Left side
1
3724A7FF
Transporting Procedure_001
1 Tow hook
1.
[1]
[2]
[3]
[4]
[5]
[6]
･
LM351
Handling Instructions
Page 5-14
Cutting Work