Baroness LM351, Руководство по эксплуатации для владельца

Страница: 55 / 75

Inspection of Pedal Stopper
Make sure that the pedal stopper fulcrum
does not rattle.
Make sure that the stopper bolt is tightened
with fixing nut.
When the pedal stopper is used, make sure
that the pedal stopper touches the
floorboard when the pedal is depressed.
Inspection of Liquid Leakage
Important
After approximately 50 hours of operation,
some tightened portions may be loosened and
liquid such as oil may leak.
Be sure to retighten the parts.
Important
Repair the machine before operation if liquid
leakage found.
Ignoring leakage will cause further trouble.
Check the bottom of the machine for
leakage of liquid such as oil, water, fuel,
etc.
Locate the leakage and identify the type of
liquid.
Inspection of Ball Proof Net
Check the ball proof net is not deteriorated.
Check there is no damage nor deformation
of the ball proof net.
Inspection of Bolts and Nuts
Important
The bolts and nuts may be loosened at the
earlier stage of the use.
Be sure to retighten or replace before
operating the machine whenever there is any
abnormality.
Check the bolts and nuts for looseness and
coming off.
Check the bolts and nuts for cracks and
damages.
Check the bolts and nuts for rust.
Check around the bolts and nuts for traces
of rust fluid.
Check for unequal bolt length.
1.
2.
3.
1.
2.
1.
2.
1.
2.
3.
4.
5.
Check the bolts and nuts for stripped
threads and abrasion.
Inspection of Hour Meter
Check the hour meter is not damaged.
Check the hour meter operates correctly.
Switch the ignition key to the "ON"
position.
Check the displayed number increases
correctly.
Switch the ignition key to the "OFF"
position.
Inspection of Water Temperature Gauge
Check the water temperature is not
damaged.
Check the water temperature operates
correctly.
Switch the ignition key to the "ON"
position.
Check the water temperature needle
swings.
Switch the ignition key to the "OFF"
position.
Inspection of Fuel Gauge
Check the fuel gauge is not damaged.
Check the fuel gauge operates correctly.
Switch the ignition key to the "ON"
position.
Check the fuel gauge needle swings.
Switch the ignition key to the "OFF"
position.
Inspection of Pilot Lamps
Check the pilot lamps are clean.
Check the pilot lamps are not damaged.
Inspection of Interlock System
Make sure that the interlock system operates
correctly.
(Refer to "Interlock System")
Repair the machine before operation
whenever there is any abnormality.
6.
1.
2.
[1]
[2]
[3]
1.
2.
[1]
[2]
[3]
1.
2.
[1]
[2]
[3]
1.
2.
Handling Instructions
LM351
Handling Instructions
Page 5-9
Inspection Before Use