Baroness LM281, Руководство по эксплуатации для владельца

Страница: 59 / 92

Pilot Lamps
Charge Lamp
The charge lamp is the left pilot lamp located
in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and the alternator
starts operating properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
ifzqmc-001
Charge Lamp_001
1 Charge lamp
Thermo-Start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the
lamp is turned off after a specified amount of
time passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
q44uug-001
Thermo-Start Lamp_001
1 Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
1ldikn-001
Oil Pressure Lamp_001
1 Oil pressure lamp
Overheat Warning Buzzer
If the water temperature inside the engine
exceeds 105 degrees Celsius, a buzzer will
sound. (intermittent tone)
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
Handling Instructions
LM281
Handling Instructions
Page 4-29
Instruments