Baroness LM281, Руководство по эксплуатации для владельца

Страница: 49 / 92

When the starter starts rotating and the
engine starts, return the ignition key to the
"ON" position slowly.
OFF
ON
GLOW
START
v2e27i-002
Procedure to Start Engine_003
Make sure that the charge lamp and engine
oil pressure lamp turn off.
If they do not turn off, stop the engine and
inspect the machine.
1 2 3
v2e27i-003
Procedure to Start Engine_004
1 Charge lamp
2 Thermo-start lamp
3 Oil pressure lamp
Move the throttle lever to the low-speed
position and let the engine warm up for 1 to
2 minutes.
Gradually move the throttle lever toward the
high-speed position.
Procedure to Stop Engine
Set the traveling pedal to the neutral
position.
Depress the brake pedal, and then apply
the parking brake lever.
Shift the reel rotation lever to the "Stop"
position.
Move the throttle lever to the low-speed
position and let the engine idle for 1 to 2
minutes.
10.
11.
12.
13.
1.
2.
3.
4.
Switch the ignition key to the "OFF"
position.
Make sure that the engine has stopped.
Remove the ignition key.
Leave the driver's seat.
Close the fuel cock.
The fuel cock is located by the side of the
fuel tank.
Safety Mechanisms
This machine features a safety device for
starting/stopping the engine.
As for starting the engine, the safety device
prevents the engine from starting unless it
meets each of the following four conditions.
An operator is sitting on the seat.
The parking brake is applied.
The reel rotation lever is shifted to the
"Stop" position.
The traveling pedal is set to the neutral
position.
The safety device will be activated and will
stop the engine under any of the following
conditions:
The operator leaves the seat without
applying the parking brake.
The operator leaves the seat while the reel
cutter (cutting cylinder) is positively
rotating.
The traveling pedal is moved when the
operator leaves the seat while the parking
brake is applied.
Warning Mechanisms
This machine features a warning mechanism
for overheating.
If water temperature inside the engine
exceeds 105 degrees Celsius, a buzzer will
sound. (intermittent tone)
5.
6.
7.
8.
9.
1.
･
･
･
･
2.
･
･
･
1.
Handling Instructions
LM281
Handling Instructions
Page 4-19
Procedure to Start/Stop Engine