26
26
27
6) Gently hold both ends of the drum shaft with panto-
graph jacks.
(If no pantograph jack is available, use an alterna-
tive and make sure that the drum shaft doesn’t come
down.)
7) Remove the right and left drum housings [6-29] out-
ward.
* If they don’t come off, remove them by tightening all-
screw bolts (M8 x 40 or larger) into the two female
screws.
After both drum housings come off, remove the right
and left jacks, and take the drum Ass’y down.
8) Lift up the handle and stand, and move the mower for-
ward.
* After moving the mower, set up the stand.
9) Assemble the corresponding parts in the reverse order
that they were disassembled.
* When assembling them, apply enough grease to the
gear tooth surface and bearings.
When installing the drum housing, apply a silicon gas-
ket to the locations that touch the frame.
1. Clean up the old gasket and any dirt attached to the
frame. (Remove grease.)
2. Apply a liquefied gasket to the packing’s surface
facing the frame (be careful not to use too much
grease), and attach the packing to the frame.
* Replace the packings as needed.
Drum shaft
If the drum housing doesn't come
off, remove it by tightening the two
all-screw bolts (M8 x 40 or larger).
Drum
housing
Drum
housing
: The area to apply
a liquefied gasket
Drum shaft
Set up the stand
