Baroness LM180E, Руководство по эксплуатации для владельца

Страница: 59 / 72

Place the tire jack beneath the jack-up point
of the rear wheel transmission area
securely, then raise it until the tire lifts off
the ground.
"Jack-up Points" (Page 5-6)
Remove the bolts.
Remove the tire from the wheel mounting
shaft.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the rear tires, reverse the
removing procedure.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Warning
If you have removed covers, etc., be sure to
securely install them in their original positions.
If covers, etc., remain removed, the operator
may come in contact with rotating parts or
belts, or foreign objects may fly off, possibly
resulting in injuries.
Important
For the specified value of belt tension, refer to
Adjusted Values.
After rotating the belt several times, check that
it has the specified tension.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
2.
3.
4.
Belt Installation Locations
Belts are installed in this machine at the
following locations.
5
3
2
6
3
4
1
l36w96-001
Belt Installation Locations_001
1 Traveling clutch
2 Reel rotation lever
3 Left and Right Mower Units
4 Transmission
5 Rear mower tension
6 Rear Mower Unit
Traveling Clutch
Loosen the adjustment bolt, then change
the length of the rod.
Adjust the clearance between the rod-
tension metal fitting and the collar to be 7 -
8 mm (0.28 - 0.31 in), when the traveling
clutch lever is engaged.
Tighten the adjustment bolt and make sure
that the collar is fixed securely.
2
5
1
A
4
3
l36w96-002
Traveling Clutch_001
1 Adjustment bolt
2 Rod
3 Traveling clutch lever
4 Rod-tension metal fitting
5 Collar
A 7 - 8 mm (0.28 - 0.31 in)
1.
2.
3.
Maintenance
LM180E
Maintenance
Page 5-17
Maintenance Work