Baroness GM2800A, Руководство по эксплуатации для владельца, Страница: 34 / 90

- 31 -
10. Long-term storage
1. Clean grass and debris from mower unit, drives, muffler, radiator and engine. Clean up
oil, grease or fuel spillage.
2. Inspect and replace the engine oil and filter element.
3. Refill oil and apply lubricating/greasing to each lubrication part.
4. Drain the fuel in the fuel tank. Do this outdoors.
5. Set the air pressure in the tires slightly higher than normal, place the machine on a
board to avoid humidity.
6. Inspect all bolts, nuts and screws tightened. If worn or damaged replace them.
7. Repair or replace damaged parts and paint peelings. Store it where is dry and free from
rain.
8. Remove the battery from the machine. If you keep the battery installed in the machine,
disconnect the grounding side (negative side).
Please refer to the Engine/Battery operation manuals for details.
Stay the machine at flat and stable place, then turn the engine off and set
the parking brake, lower the mower unit, and remove key from ignition
switch.
9. Adjustment of the other functions
1) Jack up the machine and put on a stable
stand, and float the front and rear wheels.
2) Raise the seat upwards.
3) Start the engine and run at high speed,
and put the 2WD-4WD changeover switch
into "2WD."
4) When the front wheel rotates in the
forward direction, loosen the locknut and
turn in the direction that reduces the
length of the neutral adjustment rod.
When rotating in the backward direction,
turn in the direction that extends the
length of the neutral adjustment rod. Find
the position at which the front wheel stops
and tighten the locknut.
Adjustment of the neutral position of piston pump 9-1
1) When the engine is running, stop the
engine.
2) Apply the parking brake and attach a
wheel stopper.
3) Set the 2WD-4WD changeover switch into
"2WD."
4) Raise the seat upward.
5) Turn 90 degrees of the unloading valve
beside the hydraulic pump.
Traction when the machine is
unable to travel.
9-2
Locknut
Locknut
Neutral
adjustment rod
● When you tow, drive carefully at a low speed.
● When you put the engine into operation next time, be sure to
start after returning the unloading valve.
Caution
Unloading valve