Baroness GM2800A, Руководство по эксплуатации для владельца, Страница: 18 / 90

- 15 -
Put the engine on the level surface, and
check the level of the oil by the dipstick. It will
be the proper quantity, if the oil level is
between the upper and lower limit when the
dipstick is fully inserted. If the oil level is low,
add the engine oil, and if the oil is dirty,
exchange the oil. Perform the oil level
inspection when the engine is suspended and
after 10 to 20 minutes or more past. Please
keep in mind that it becomes engine failure
and cause of accident if the engine oil added
too much.
Perform refilling of the engine oil from the oil
filler. It takes some time for the added engine
oil to fall in oil pan. Inspect the oil level again
in 10 to 20 minutes after adding the engine
oil.
*
Never mix different kind of engine oil.
* Use the engine oil higher than the API
service classification CD class, and SAE
viscosity suited to the application
environment (temperature).
* The engine oil tank capacity is
approximately 10L.
Inspection and refilling of engine oil
1-4
Dipstick
Upper limit
Lower limit
Oil filler cap
Inspection of the hydraulic oil
1-5
Cleaning of the air cleaner
1-6
Level the engine and raise the mower unit.
Always check whether the hydraulic oil level
is at the center of oil level gauge, and supply
oil if the level is low.
When refilling the hydraulic oil, use the
ShellTellus 46 or equivalent type.
*
Do not mix hydraulic oil of different kind
by any means.
* The tank capacity is approximately 44L.
Oil level gauge
Perform the inspection with the vacuum
pressure indicator. If the element of the air
cleaner becomes dirty, the red ring is visible
in the vacuum pressure indicator. Remove
and clean the air cleaner.
If the element of the air cleaner is dirty, it will
become the cause of the engine malfunction.
When it's dirty, clean it by carefully tapping
the element or blowing air from inside so that
the element may not be damaged.
Replace the element of the air cleaner every
200 hours.
Attach the element after clean up and push
the reset button.
Air cleaner
Reset button
Vacuum pressure indicator