Move the brake shoe to the position where it
is flush against the inside of the pulley drum.
2
1
wt6ous-002
Adjustment of Knife Brake_002
1
Pulley drum
2
Brake shoe
Tighten the bolt mounting the brake shoe.
Adjust the knife tension return spring.
Install the rear cover.
Start the engine.
Set the knife rotation lever to the "Rotation"
position.
Make sure that the rotary knife rotates, and
then set the knife rotation lever to the "Stop"
position and make sure that the rotary knife
stops rotating within 7 seconds.
Adjusting the Neutral Position of the Piston
Pump
Caution
Make sure not to touch rotating tires.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
"Jack-Up Points" (Page 5-5)
Remove the seatback cover on the right
side.
Remove the underseat cover on the right
side.
Start the engine, and rev it up to the
maximum rpm.
4.
5.
6.
7.
8.
9.
10.
1.
2.
3.
4.
5.
Set the 2WD/4WD selector switch to the
"4WD" position.
Adjust the neutral position for the rear
wheels.
If the rear tires rotate forward, loosen the
cam lever shaft, and then adjust lock nuts
A to move the shaft seat backward.
Find the position where the rear wheels
stop, and then tighten the cam lever shaft
to secure it.
If the rear tires rotate in reverse, loosen
the cam lever shaft, and then adjust lock
nuts A to move the shaft seat forward.
Find the position where the rear wheels
stop, and then tighten the cam lever shaft
to secure it.
5
6 7
1
4
3
2
hsn2jo-020
Adjusting the Neutral Position of the Piston Pump_001
1
Cam lever
2
Cam lever shaft
3
Shaft seat
4
Lock nut A
5
Threaded rod
6
Lock nut B (right-hand screw)
7
Lock nut C (left-hand screw)
Important
Before adjusting the neutral position for the
front wheels, make sure that the rear wheels
have first been set to the neutral position.
Adjust the neutral position for the front
wheels.
If the front tires rotate forward, loosen lock
nuts B and C of the threaded rod, then
turn the threaded rod to shorten the
connection.
Find the position where the front wheels
stop, and then tighten lock nuts B and C.
6.
7.
[1]
[2]
8.
[1]
GM1700
Maintenance
Page 5-14
Maintenance Work
Содержание GM1700
