Baroness GM1700, Руководство по эксплуатации для владельца

Страница: 54 / 87

Water Temperature Gauge
The water temperature gauge is located in the
operation panel.
This instrument indicates the water
temperature inside the engine.
If the water temperature gauge indicates a
level close to "H" during operation, the machine
is overheated.
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
If the water temperature exceeds 105 °C (221
°F), a buzzer will sound.(Intermittent tone)
1
igozke-001
Water Temperature Gauge_001
1 Water temperature gauge
Pilot Lamps
Charge Lamp
The charge lamp is the left pilot lamp located
in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and the alternator
starts operating properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
ifzqmc-002
Charge Lamp_001
1 Charge lamp
Thermo-Start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the
lamp is turned off after a specified amount of
time passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
q44uug-002
Thermo-Start Lamp_001
1 Thermo-start lamp
GM1700
Handling Instructions
Page 4-26
Instruments