Baroness FS900, Руководство по обслуживанию

Страница: 144 / 163

Disengage the left and right slide latches.
1
xsi3tb-003
Change of Rotary Plates_004
1 Slide latch
Remove the brush cover.
1
xsi3tb-004
Change of Rotary Plates_005
1 Brush cover
Remove the bolts securing the rotary plate.
1
2
2rp7t3-001
Change of Rotary Plates_006
1 Bolt
2 Rotary plate
Remove the rotary plate.
6.
7.
8.
9.
Install a new rotary plate.
Caution
Evenly install the rotary plate.
Adjust the rotary plate so that there is a
clearance of approximately 5 mm between
it and the brush frame, and then temporarily
tighten the bolts.
A
2
1
2rp7t3-002
Change of Rotary Plates_007
1 Brush
2 Brush frame
A 5 mm
Slowly rotate the rotary plates by hand, and
then follow the same steps to adjust the
remaining rotary plates and temporarily
tighten the bolts.
Caution
Refer to "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Do not forget to tighten bolts properly.
Slowly rotate the rotary plates by hand,
check the clearance again and tighten the
bolts.
After making adjustments and tightening
the bolts, tighten all bolts firmly.
Install the brush cover.
Start the engine, rotate the rotary plates,
and then check that there is no contact
between or vibration in the rotary plates and
brush frame.
10.
11.
12.
13.
14.
15.
16.
FS900
Operating Machine and Mower Units
Page 7-26
Inspection and repair of each section